Cool. The conversion works out to 1 blender unit = 1 mm, so as long as the largest fit on a 140 by 140 sheet (and less than 100 units tall) it should be fine. Of course the parts should probably be scaled up by a factor of 10 if you want them to be of reasonable size. Details smaller than 2 blender units probably won't print.
This will make a fun test to see if I can take a model and print it and how much work is involved.
Also for coloring I can always print on of these. Though probably not for the first few prints.
E: "Did they... did they just endorse the combination of the JSDF and US Army by showing them as two lesbian lolicons moving in together and holding hands and talking about how 'intimate' they were?"
B: "Have you forgotten so soon? They're phasing out Don't Ask, Don't Tell."
This will make a fun test to see if I can take a model and print it and how much work is involved.
Also for coloring I can always print on of these. Though probably not for the first few prints.E: "Did they... did they just endorse the combination of the JSDF and US Army by showing them as two lesbian lolicons moving in together and holding hands and talking about how 'intimate' they were?"
B: "Have you forgotten so soon? They're phasing out Don't Ask, Don't Tell."