Some people have gotten it working, but it tends to be a far more complicated (and expensive) setup.
the general rule of thumb is that there is a maximum of 45 degree overhang, though if properly calibrated they can do 90 degree 'bridges'. Ie: print at almost any overhang as long as it's strait to another point. It will likely take me a while to properly calibrate the machine, so the 45 degree rule should probably be observed.
E: "Did they... did they just endorse the combination of the JSDF and US Army by showing them as two lesbian lolicons moving in together and holding hands and talking about how 'intimate' they were?"
B: "Have you forgotten so soon? They're phasing out Don't Ask, Don't Tell."
the general rule of thumb is that there is a maximum of 45 degree overhang, though if properly calibrated they can do 90 degree 'bridges'. Ie: print at almost any overhang as long as it's strait to another point. It will likely take me a while to properly calibrate the machine, so the 45 degree rule should probably be observed.
E: "Did they... did they just endorse the combination of the JSDF and US Army by showing them as two lesbian lolicons moving in together and holding hands and talking about how 'intimate' they were?"
B: "Have you forgotten so soon? They're phasing out Don't Ask, Don't Tell."