it ground through the feestock because the filament didn't go anywhere. think of it as a really messy cut through the feestock, not the consumption of the entire feedstock. does that make it clear? Basicly the extruder motor was going and the part of the filament in connection with the axe was going but the rest of the filament stayed stationary.
E: "Did they... did they just endorse the combination of the JSDF and US Army by showing them as two lesbian lolicons moving in together and holding hands and talking about how 'intimate' they were?"
B: "Have you forgotten so soon? They're phasing out Don't Ask, Don't Tell."
E: "Did they... did they just endorse the combination of the JSDF and US Army by showing them as two lesbian lolicons moving in together and holding hands and talking about how 'intimate' they were?"
B: "Have you forgotten so soon? They're phasing out Don't Ask, Don't Tell."