I've been printing in 1/3125 to fit with my growing collection of Starline 2500 minis, so the Stalker is about 60mm long. It printed without problems, no need for reinforcements.
And yes, I explicitly design around the limitations of Shapeways' WSF process, so fine details are not exactly on the table.
(Wait, engine pods? The Stalker is a one-nacelle ship...)
--
Sucrose Octanitrate.
Proof positive that with sufficient motivation, you can make anything explode.
And yes, I explicitly design around the limitations of Shapeways' WSF process, so fine details are not exactly on the table.
(Wait, engine pods? The Stalker is a one-nacelle ship...)
--
Sucrose Octanitrate.
Proof positive that with sufficient motivation, you can make anything explode.